![]() Iptables -A FORWARD -i eth0 -o wlan -j ACCEPT Iptables -A FORWARD -i wlan1 -o eth0 -j ACCEPT This is done with iptables the standard series of commands would be something like: sysctl -w _forward=1 ![]() You could use the linux virtual bridge, for this, but I think it is more commonplace to use IP forwarding and NAT. Trying to shove them together is not a simpler solution. You could also consider it technically similar to an access point. What you describe in "desired function" is a network bridge, except perhaps it is unidirectional in some sense, which is essentially a router: Instead of an uplink, you have another subnet on the eth interface. However, I cannot access the eth0 connected device when I am connected via wifi, presumably because it is on a different subnet. So far I have managed to get my eth0 and wlan1 adapters configured to give IPs on two different subnets with the below dnsmasq and dhcpcd configurations # nfĭhcp-range=wlan1,192.168.4.2,192.168.4.99,24hĭhcp-range=eth0,192.168.5.1,192.168.5.99,24h User can access configuration interface of eth0 connected device via local IP address.Separate device connects to RPi via eth0 and is given an IP. ![]() User connects to RPi AP via wlan1 and is given an IP.I'm trying to configure my RPi to give me access to devices conencted either of eth0 or wlan1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |